Fisher & Paykel DISHDRAWER DD60DTX6HI1 User Manual page 39

'A' fault codes
Follow the steps below to try and fix the issue.
DISPLAY
+ all modifiers
RINSE
, + all modifiers
ECO RINSE
, + all modifiers
GLASSWARE ECO
, +
GLASSWARE ECO
+ all modifiers
FAULT CODES
POSSIBLE CAUSE
Water
A1:
Supply fault.
A3:
drain:
The filter may
be clogged
or installed
incorrectly.
The drainage hose
connection to
kitchen drainpipe
may be blocked.
A6:
arm has loosened
or come off its
mounting, or
water pressure
is too low, or a
combination of low
water pressure and
excessive foaming.
A7:
program –
DishDrawer™
Dishwasher has
RINSE
detected excess
foam in the drawer.
WHAT TO DO
1 Ensure the water supply is
2 Press
3 Press
Drawer cannot 1 Ensure the filter is clean and
2 Press
3 Press
1 Ensure the drainage hose
2 Press
3 Press
The spray 1 Open the drawer and check the
2 If the spray arm has loosened
3 Press
4 Press
Auto recovery 1 Let the auto recovery program
2 Check that you are using the
3 If the drawer is still filled with
turned on.
once to stop the beeping,
then again to clear the fault.
to resume the
wash program.
installed correctly. Refer to
'Removing and cleaning the filter'
and 'Replacing the filter''.
once to stop the beeping,
then again to clear the fault.
to resume the
wash program.
connection at sink trap, waste tee
or standpipe is not blocked.
once to stop the beeping,
then again to clear the fault.
to resume the
wash program.
spray arm.
or come off its mounting,
re-fit it. Check that it is firmly
seated and turns freely.
Refer to 'Maintenance'.
once to stop the beeping,
then again to clear the fault.
to resume the
wash program.
run until it is complete. The
wash program will resume when
the auto recovery program
has completed.
right detergent before running
another wash program.
foam at the end of the wash
program, contact Customer Care.
39