Fisher & Paykel DISHDRAWER DD60DTX6HI1 User Manual page 33

Removing and cleaning the filter plate
Locking nut
filter plate
Refitting the filter plate
o-ring
Winterizing (cold climates)
If the DishDrawer™ Dishwasher is installed in a cold climate where temperatures fall below
zero, we recommend winterizing.
1
2
3
MAINTENANCE
With the filter and spray arm removed, twist the
locking nut anti-clockwise and lift out. Carefully lift
the filter plate out and clean under hot soapy water
before rinsing thoroughly.
Before refitting the filter plate, ensure the O-ring is
correctly positioned in the tub as shown.
Push the filter plate back into the tub ensuring there
are no particles in the recess. Secure in place by
lowering the locking nut into position and aligning
the arrows by rotating clockwise.
Turn off the water supply.
Disconnect the drain hoses from the sink
drain pipe and the water inlet pipe from the
water valve.
Drain the water from the hoses, inlet pipe
and water valve, using a bucket or pan to
collect the water.
Reconnect the water inlet pipe to the water
valve and hoses to the sink drain pipe.
Remove the filter, spray arm, locking
nut and the filter plate from the bottom
of the drawer. Use a sponge to remove
any remaining water from underneath
before replacing.
33