Fisher & Paykel DISHDRAWER DD60DTX6HI1 User Manual page 36

PROBLEM
Flashing wash
modifier
indicators
Intermittent
beeping
DishDrawer™
Dishwasher will
not start
Fan noise after
a wash program
has finished
Fan noise starts
when I close the
drawer, even
though I didn't
start a new wash
No powdered
detergent
dispensed
The wash seems
to have finished,
but the drawer
will not open
Water pooling
on inner rim of
drawer after
a wash
Water under
the filter
Excess water in
the drawer
36
TROUBLESHOOTING
POSSIBLE CAUSES
A fault has occurred.
DishDrawer™ Dishwasher
is paused.
Power supply is
not connected.
The drawer is not
closed correctly.
is on.
KEYLOCK
Cycle not started
Too much time passed
between pressing
closing the drawer.
DishDrawer™ Dishwasher
is in Demo mode.
This is normal. The fan
continues to run to assist
with drying.
This is normal. In some
cases, the fan will run
when the drawer is closed
for a set time after a
program has finished.
Detergent dispenser was
wet when loaded.
The wash is still in
progress. It is in a quiet
phase that is needed for
optimal performance.
This is normal
condensation.
This is normal.
Drain hose(s) bent.
Blocked filters.
WHAT TO DO
Refer to 'Fault codes'.
Open the drawer and press
Connect the power supply.
Ensure the drawer is firmly closed.
Turn
KEYLOCK
Refer to 'Wash Programs'
Open the drawer and press , close the
and
drawer within 7 seconds.
Contact Customer Care.
The fan will automatically stop after a set
time, or when the drawer is opened. the fan
may resume when drawer is closed again.
The fan will automatically stop after the set
time is over.
Clean the dispenser and ensure it is
dry before adding detergent. Refer to
'Detergent' for more information.
No action required. The program will
transition into a more audible phase after
the quiet phase is over.
Wipe dry.
No action required.
Straighten the drain hose(s).
Refer to 'Maintenance.'
off. Refer to 'Keylock'.