Automatic Bok Ssestesee Siesttunce Ters Onnesacstucesnnonscean Busiest Se Nuecvedaes Gdowerstcevdugevactietal Abate Onemeaa Cacade Eee Minsedees; Cto Oa Caacd En Sakes Ote Lade Beac Ured Oatiluarceyccale Snioaueac Eda Spuds Aeduaraacetear Tet Eecbs Ome Eara Ny Sheen Seer - Pioneer VSX-9700S Operating Instructions Manual

TUNER
AUTO OR MANUAL TUNING
1. Press the POWER switch to the ON position.
NOTE:
Be sure to turn the TAPE 2 MONITOR switch OFF when listening to
AM or FM broadcasts.
2. Use the BAND selector to choose either FM or AM.
AUTO tuning:
Auto tuning is convenient when you do not remember the frequency
of a desired station, or when you wish to find stations that you do not
normally listen to.
For AUTO tuning:
3. Set the AUTO/MANUAL switch to the auto tuning mode.
© In the Auto Tuning mode, the indicator will light.
4. Press the '+' or '-'' switch of the TUNING switches.
© Pressing ''+'' causes scanning to take place in the direction of
increasing frequency. Pressing "'—'' causes scanning to take place
in the direction of decreasing frequency.
© When a station is received, scanning will stop (the
indicator lights). If you wish to receive a different station, press
the TUNING switch (+ or ''—"") again.
18
<ARB1234>
5 4 HITS FM MODE
switch AUTO/MONO switch
MANUAL tuning:
This is the ''normal'' tuning mode. Each time the TUNING switch '+'
or "'—"' is pressed, the tuning frequency changes by one channel step,
allowing you to find stations manually.
For MANUAL tuning:
3. Set the AUTO/MANUAL switch to the manual tuning nnode.
© When in the Manual Tuning mode, the indicator will go
out.
4. Press the ''+'' or "'-"' switch of the TUNING switch as necessary
to set to the frequency of the desired station.
¢ Each time the switch is pressed, the tuning frequency will change
by one step in the direction corresponding to the switch pressed.
When pressed continuously, the reception frequency will also
change continuously.
¢ When a station is received, the indicator will light.
© When the received station is broadcasting a program in FM stereo,
the indicator will light. The STEREO indicator will not
light if the FM MODE switch is set to FM MONO.
5. Adjust the MASTER VOLUME and tone as desired.
NOTE:
© When Auto Tuning is used, correct reception may not be possible
for very distant stations or stations with very weak signals. In this
event, Manual Tuning is recommended.
© The [ TUNED | indicator may not light with broadcasts received over
long distances, or when the broadcast signals are extremedy weak.
HITS function
When the HITS switch is pressed, the receiver searches from the current
frequency for the nearest station and tunes in the first oneit finds. If
no receivable station is found within the band range, the receiver retums
to the state it was in before the switch was pressed.