Panasonic AW-PH300 Operating Instructions Manual page 9

Camera Guide Pin
e Fastening the Camera Mounting Plate
To mount the pan/tilt head upright, pull out the Camera
Guide Pin @ from the Camera Mounting Plate @,
which is packed together with the panftilt head, and
insert it into the hole shown in the figure below
This is not necessary when mounting the panftilt head
suspended
e Loosen the Camera Guide Pin Q with a screwdriv-
er and remove it
e Insert the Camera Guide Pin Q into the hole
shown' below and fasten it securely with a Screw-
driver
Camera Mounting Screw position
Pin position for
mounting upright
Camera Mounting Plate
he a
Fasten the Camera Mounting Plate @ as shown in the
figure right
The Camera Mounting Plate @ and Camera Mounting
Plate Fixing Screws are packed together
The position of the Camera Mounting Plate @ differs
depending on the camera and lens used
It is recommended that the position of the Camera
Mounting Plate @ be so adjusted that the gravity cen-
ter of the camera and lens will be perpendicular to the
tilting center
<Mounting suspended>
Camera Mounting Plate
Camera Mounting Plate
Fixing Screw
<Mounting upright>
KA