Panasonic AW-PH300 Operating Instructions Manual page 19

@ Connecting Other Controllers
P/T CONTROL IN (CONTACT/RS-232C}
Connect it in case of controlling the panftilt head with a
contact type controller, or via an RS-232C Have a
cable ready which meets the signal requirements
specified in the pin assignment table below TThe
cable must have a nominal cross section of 0 3 mm? or
more and meets the UL specifications
The applicable connector is a bellows type 28-pin
(1 27-mm pitch) plug
Note: When using a contact tvpe controller or an RS-
232C, the switches must be set as specified in the
item on the use of contact tvpe controller, RS-
232C in the section BEFORE INSTALLING at page
It is recommended that the limiters (operating range)
be set before use
Depending on where the panftilt head is instalied, the
camera might contact an obstacle present in the oper-
ating range
In such a case, the limiters mav be set to prevent the
camera from contacting such an obstacle
The limiters can be set from the control panel at four
points upper limit, lower limit, left limit, and right limit
Once the limiters are set, the set positions remain valid
even if power is switched off
Contact Signal | RS-2320 Sina
Not used Not used
Not used TXD
Not used RXD
GND GND
UP Not used
DOWN Not used
LEFT Not used
RIGHT Not used
RUN_SIG Not used
Not used Not used
DI OPT SEL Not used
Not used Not used
Panftilt head send data
Panftilt head receive data
Up tilt control input
Down tilt control input
Left pan control input
Right pan control input
Output signal showing head running
Panfilt head and camera power control input
GND GND