Panasonic AW-PH300 Operating Instructions Manual page 12

Setting the Cable Compensation Circuit
lf the panftilt head is connected to the controller with
coaxial cabies (5C-2V), the maximum allowabie dis-
tance between them is 500 meters If the cable length
between them is more than 300 meters, however, set
the. cable compensation circuit switch to the ON posi-
tion as described below
Remove the 4 screws from Control Connector Panel B
and pull out the panel toward vourself
Set the switch on the PCB on the back of the panel to
the ON position
Mount Control Connector Panel B back and fasten it
with the screws
-10-
e Changing Others
Changing the Position of Control Connector Panil
The position of Control Connector Panel @ can be
changed ii necessarv
* Remove the blank panel in the position where you
wish to mount Control Connector Panel (B.
e Remove the screws from Control Connector Panel
(B and pult out the panel up front
e Disconnect all the 6 connectors on the PCB on the
back of the panel
e Take Control Connector Panel to the desired posi-
tion, and connect the PCB connectors back as
before
e Fasten Control Connector Panel B and the blank
panel with the screws
Changing the Direction of Control Connector Panel.
The direction of Control Connector Panel & can be
changed by 180° if necessary
e Remove the screws from Control Connector Panel
(B and pull out the panel up front
e Turn the panel 180°, and place it back in position
+ Fasten the panel with the screws
Changing the Direction of Camera Connector Panel
The direction of Camera Connector Panel @ can be
changed by 180° if necessary
e Remove the screws from Camera Connector Panel
© and pull out the panel up front