Table of Contents
Advertisement
Step 2
Setting up the
remote commander (continued)
COMMAND
MODE VTR
1/2/3
Note
¢ If you set the COMMAND
MODE VTR OFF/1/2/3
selector on the VCR to
"OFF," you can no longer
control this VCR from any
other Sony remote
commanders.
8 | Getting Started
setung the commana
moae
You can select three different positions for the command mode setting.
1
Turn on the VCR, then press OPERATION PANEL OPEN/
CLOSE to open the operation panel.
Set the COMMAND MODE VTR OFF/1/2/3 selector on the
VCR to "VIR 2."
2
Set the COMMAND MODE VTR 1/2/3 selector
on the remote
commander
to "VIR 2."
3
Set the[Tv|(ViR|remote control selector on the remote
commander to "[VTR]."
Controlling other Sony video equipment if other Sony video
equipment has a COMMAND MODE selector
1 Set the COMMAND MODE 1/2/3 selector on the remote commander
to a position other than the one you selected for this VCR.
2 Set the COMMAND MODE selector of any other video equipment to
the same position you selected in step 1.
If other Sony video equipment does not have a COMMAND MODE
selector
You can control other Sony video equipment using the following
COMMAND MODE settings.
1) Infrared remote controlled Sony Betamax VCRs: position 1 (Some
units may not be controlled in this mode.)
2) Sony 8 mm format VCRs: position 2
3) Sony VHS format VCRs: position 3
Advertisement
Table of Contents
