Sony EV-S7000 Operating Instructions Manual page 51

Notes
¢ When the EDIT switch is set
to ON, the PICTURE
ADJUST settings are
automatically set to default.
© Usually the default setting
are adequate unless the tape
is of poor quality or
recording was made on
another VCR.
Press CURSOR </> to move the
tracking bar (M) to adjust the
sharpness.
Press EXECUTE.
The new sharpness adjustment appears
on the screen.
To store your settings in memory,
follows steps 1 to 3, then make
your settings, then do the
following:
1 Press CURSOR 4/¥ to move the
cursor (P) to WRITE MEMORY.
2 Press EXECUTE to enter the settings.
To recall your stored setting,
press READ MEMORY.
When you want to change settings, press
CURSOR 4/T¥ to move the cursor (b>) to
RESET, then press EXECUTE to delete the
current settings. These are automatically
reset to the default settings as adjusted at
the factory at the time of shipment.
PICTURE ADJUST
HUE
ome)
COLOR
PSHARPNESS
YIC DELAY
RESET
WRITE MEMORY
READ MEMORY
Push 4 >
PICTURE ADJUST
HUE
coLoR
PSHARPNESS
yiC DELAY
RESET
WRITE MEMORY
READ MEMORY
Push 4 >
cme —
PICTURE ADJUST
HUE
coLvor
SHARPNESS
vic OELAY
RESET
PWRITE MEMORY
AEAD MEMORY
PICTURE ADJUST
HUE
COLOR
SHARPNESS
WRITE MEMORY
READ MEMORY
Additional Operations | 5{