Table of Contents
Advertisement
Editing
Shuttle editing
Note
¢ During shuttle editing, use
the JOG dial/SHUTTLE ring
on the VCR, not on the
remote commander.
|
(oe ob)
58 | Editing
al PAUSE
This section shows you how to edit VCR recordings in the most basic
way: shuttle editing. The VCR also provides the following ways of
editing:
Editing to or from another VCR or camcorder—"Editing with another
VCR" (page 60).
Editing via the LANC @ or CONTROL S jacks of two VCRs—
"Synchronized editing" (page 62).
Taking events from one tape and assembling them onto another tape
in any order—" Assemble editing" (page 66).
Adding music or narration on the PCM track—"Audio dubbing"
(page 70).
During recording
If you want to cut out events such as TV commercials, you can pause
recording and play back the tape in the reverse direction until the
beginning of an unwanted event is reached. Then, record over it. This
feature only works from the VCR. During timer recording, you can't use
this function.
Press If PAUSE during recording.
The VCR enters recording pause mode.
Turn the JOG dial/SHUTTLE ring on the VCR counter-
clockwise to rewind the tape until the unwanted event
appears.
If you turn the JOG dial/SHUTTLE ring, you can select the playback
speed by how fast you turn it, and if you turn it.
When you release the dial or ring, the VCR enters recording pause
mode.
Press 18 PAUSE when a desired event appears on the
screen.
Recording starts.
Advertisement
Table of Contents
