Table of Contents
Advertisement
Tip
¢ For the purpose of protecting
the tape, when you are in
recording pause mode, after
5 minutes the VCR
automatically enters the stop
mode.
Notes
When you press BACK, the
VCR returns to the last frame
of the event you have
selected. Press BACK again
to return to the first frame of
the event.
If you haven't designated an
end frame, the tape records
through to the end.
If you press #8 PAUSE
during assemble editing, the
event you are editing is set. If
you have another event, the
next event is also
automatically edited.
During fast-forwarding or
rewinding, if the TIME
CODE indicator on the
playback VCR should show
"e:~;—", the assemble editing
function may not work. In
this case, please use the
synchronized editing
function instead.
To assemble edit more than 8 events
Repeat the above described procedure to assemble edit the additionally
required number of events.
1 After you've finished one assemble editing session, press ASSEMBLE
The assemble editing mode is cancelled. The contents stored in
memory are deleted.
2 When the VCR enters recording pause mode, press M STOP.
3 Repeat from step 1 on page 67.
To change the settings stored in memory
Press BACK on the VCR.
Only the last event you have entered for assemble editing can be
changed. If you press BACK twice in a row, the event entered last is
deleted.
To check the settings stored in memory
Press &@ STOP. To cycle through the designated events, press BACK.
To stop assemble editing temporarily
Press SYNCHRO EDIT/START. When you wish to resume assemble
editing, editing starts from the first event.
Editing | 69
Advertisement
Table of Contents
