Tunturi UB60 User Manual page 14

English
Description illustration A
The illustration shows what the trainer will looks like after the
assembly is completed�
You can use this as a reference during your assembly, but do follow
the assembly steps always in the correct sequence as showed in the
illustrations�
Description illustration B
The illustration shows what components and parts you should find
when un-boxing your product�
‼ NOTE
• Small parts can be hidden/ packed in hollow spaces in the
Styrofoam product protection
• If a part is missing, contact your dealer�
Description illustration C
The illustration shows the hardware kit that comes with your product�
The hardware kit contains bolts, washers, screws, nuts etc� and the
required tools to properly fit your trainer�
Description illustration D
The illustrations shows you in the correct following order how to
assembly your trainer best�
‼ NOTE
• Part numbers shown in the assembly steps are commencing
with the spare part drawing that can be found in the online full
version user manual�
⚠ WARNING
• Assemble the equipment in the given order�
• Carry and move the equipment with at least two persons�
⚠ CAUTION
• Place the equipment on a firm, level surface�
• Place the equipment on a protective base to prevent damage to
the floor surface�
• Refer to the illustrations for the correct assembly of the
equipment�
Fasten Nuts and Bolts
Securely tighten all Nuts and Bolts after
all components have been assembled in
current and previous steps�
‼ NOTE
• Do not over tighten any component with pivoting function�
• Make sure all pivoting components are able to move freely�
Do not tighten all Nuts and Bolts in this
step�
Free area (Fig� D-0)
Adequate space is a prerequisite for use�
The free area should be no less than 0�6m greater than the *training
area in the directions from which the equipment is accessed�
The free area must also include the area for emergency dismount�
Where equipment is positioned adjacent to each other, the value of
the free area may be shared�
*Training area is the maximum length/width/ height of the trainer,
including moving parts, been measured to its maximum length/
width/ height during use�
IMPORTANT
Because your trainer will/ can set in the first using hours, we
recommend you do a quick check on the hardware you have fitted
during your assembly�
We suggest tightening all bolts and nuts once again after the first
few workout sessions (approximate 10 hours)�
Just to assure the bolts and nuts are still tightened well for your
trainer's best performance�
‼ NOTE
• We recommend checking the hardware regularly, at least once
every 3 months�
Additional information
Packaging disposal
Government guidelines ask that we reduce the amount of waste
material disposed of in land fill sites� We therefore ask that you
dispose of all packaging waste responsibly at public recycling centres�
End of life disposal
We at Tunturi hope you enjoy many years of enjoyable use from
your fitness trainer� However, a Time will come when your fitness
trainer will come to the end of its useful life� Under 'European WEEE
Legislation you are responsible for the appropriate disposal of your
fitness trainer to a recognised public collection facility�
Use
Using weight plates
- When using weight plates, do make sure to use sufficient locking
supports to secure your weight plates at all times before use�
- Never exceed the maximum weight capacity of the barbell bar and
or bench�
To take not of your own body weight too�
Adjusting the backrest inclination
(Fig. U-2)
- Tilt the backrest slightly and tilt the adjusting bar out of the
toothed plates�
- Move the backrest into the required position�
- Position the adjusting bar in the toothed plates to secure it�
Adjusting the vertical seat position
(Fig. U-3)
- Pull the adjustment knob�
- Move the seat to the required position�
- Release the adjustment knob�
1 4