Battery Information; Nicd Battery Pack (Pb-32/Pb-34); Installing/Removing The Battery Pack - Kenwood TH-22A Instruction Manual

BATTERY INFORMATION
NiCd BATTERY PACK (PB-32/PB-34) Note:
You must charge the battery pack before you can use it paliabarging: shculc:be dove within an ambien.
charg ry Pp ay : temperature between 5°C to 40°C (41°F to 104°F).
The pack is delivered uncharged to provide you with the Recharging outside this range may not fully charge the
greatest number of charge/discharge cycles. It takes battery.
several charge/discharge cycles before achieving the full > ff the entire display is blinking, or if turning PWR/VOL
battery pack capacity. After storing the pack for more Coes Ns nat power the transceiver, recharge the
attery pack.
than 2 months, recharge it before use.
» The BC-17 charger is designed to recharge only PB-32,
PB-34, PB-30 (option), or PB-33 (option). Never use
: the BC-17 to recharge other types of batteries.
mg Recharging
Insert the plug from the BC-17 charger into the DC IN a Installing/Removing the Battery Pack
jack on the right side of the transceiver. Then plug Insert the battery pack into the bottom of the
the charger AC plug into an AC wail outlet. Do not transceiver, and push in until the tab on the pack
charge the battery for more than 15 hours. Exceeding locks in place.
the recommended charge period shortens the useful
life of the pack and adversely affects battery
performance.
; To remove the battery pack, simultaneously press the
DC IN jack tab on the back of the pack while pulling out the pack
from the transceiver.