Table of Contents
Advertisement
WIRELESS KEYPAD PROGRAMMING (IF APPLICABLE)
Scan Code for a video of the complete installation and programming.
Program Keypad before mounting
STEP 1) PROGRAMMING A PIN NUMBER (Single Door)
Program the keypad for the first time* with a Personal
Identification Number (PIN). This PIN must be 3 to 8 digits.
1. Ensure number pad back lighting is off.
2. Press 3-5-7 in sequence.
3. Press PROGRAM key. LED will blink once per second.
4. Enter a PIN number (3-8 digits).
5. Press PROGRAM key. LED will blink twice and shut off.
STEP 2) PROGRAMMING THE KEYPAD TO 1 OPERATOR
1. Place garage door operator into PROGRAMMING MODE.
2. Ensure number pad back lighting is off.
3. Enter the PIN number on keypad.
4. Press the UP/DOWN key 3 to 4 times slowly until garage door
operator operates.
STEP 3) OPERATING THE KEYPAD WITH THE OPERATOR
Single Door Operation:
1. Ensure number pad back lighting is off.
2. Enter PIN number.
3. Press the UP/DOWN key.
4. Operator will operate.
NOTE:
Keypad will remain active for 15 seconds after a successful entry is
made. During this 15 seconds ANY key will operate the operator.
BUILT IN VEHICLE TRANSMITTER PROGRAMMING (IF APPLICABLE)
Homelink® Programming
Step 1) Clear HomeLink
Clear HomeLink by pressing and holding down the first and third buttons until the indicator on the HomeLink blinks
slow and then fast for 20 seconds; then release both buttons.
NOTE: Clearing the HomeLink will remove all previously programmed garage door operators.
Step 2) Train HomeLink to the Genie Remote
• Choose the button on the HomeLink that will be used to open the door.
• Hold down the Genie remote button. While holding, press and hold the chosen HomeLink button.
• Hold down both buttons until the indicator on the HomeLink blinks slow then fast. Once it blinks, release both buttons.
Step 3) Program HomeLink to the Genie Operator
• Place operator into programming mode. (See panel at left)
• Press programmed Homelink button 3 - 4 times or until door operates.
NOTE: For additional instructions see the vehicle owners manual, or www.homelink.com
Car2U Programming
Step 1) Clear Car2U to default settings
• Press and hold buttons 1 and 3 for 20 seconds or until all three LEDs begin to flash.
• Release both buttons. The Car2U system is now set to the Factory Default settings
NOTE: Clearing the Car2U remote will remove all previously programmed garage door operators.
Step 2) Program Car2U to the Genie Operator
• Place operator into programming mode. (See panel at right) Press and hold the desired Car2U button until door begins to move.
• Release button for one second.
• Press same button again, door should move.
NOTE: For additional instructions see the vehicle owners manual.
QuickView Single Door setup.
Please see complete instructions that accompany keypad
.
Activate keypad by opening battery
compartment and pull protective
tab. Reinstall compartment door to
PUTTING OPERATOR INTO PROGRAMMING MODE:
1. Press and hold the program button on the operator
until the round LED turns blue, then release.
2. The round LED will go out and the long LED will begin
flashing purple.
3. Complete programming steps.
PRGM
PRESS
&
SET
RELEASE
Solid Blue
NOTE: The operators LEARN LED will time out in 30 seconds.
Programming must be completed within 30 seconds.
begin programming.
TAB
PRGM
SET
Flashing Purple
29
Advertisement
Table of Contents
