Install And Wire Wired Wall Console - Genie GCL-LT Manual

INSTALL AND WIRE WIRED WALL CONSOLE

CAUTION
!
When using insulated staples, make only snug enough to hold electrical wire in place. Staples too tight can
cause damage to wire and cause wall control to malfunction.
WARNING
!
Use of any other wall control can cause unexpected operation of the door and loss of lighting feature.
Locate wall console within sight of door and far enough from door to prevent contacting it while operating
the console. Control must be at least 5 feet above floor to prevent small children from operating it.
1. Route supplied wire from operator to the desired location for the wall control. Secure wire with insulated
staples (green bag).
2. On the operator: insert wire down through the control wire channel. Remove 1/4" insulation from
white and striped wire. Using a small flat head screwdriver, press in the orange tab and insert the white
wire in terminal 3 and the striped wire in terminal 4. Ensure the wires are secure in each terminal; adjust as
necessary. FIG. 12.
3. At the wall console end of the wire, remove 1/4" insulation from the white and striped wires and secure the
white wire to the "W" terminal and the striped wire to the "B/W" terminal as shown. Ensure the wires are
secure at each terminal; adjust as necessary. FIG. 13.
4. Mark the wall console mounting holes, drill 3/32" pilot holes and mount with #6 x 1-1/4" screws. If mounting
to drywall, anchors will be required (not provided). FIG. 13.
5. Post the "ENTRAPMENT WARNING LABEL" placard in the box next to the wall console. (Use alternate label for
riDCM model operators, see owners manual). FIG. 13.
1 2
PHOTOCELL WIRES:
White Wires to Terminal 1
Striped Wires to Terminal 2
Push in on Tabs to
Insert Wire
3 4
WALL CONSOLE WIRES:
White Wire to Terminal 3
Striped Wire to Terminal 4
FIG. 12
CAUTION
!
Lorsque vous utilisez des agrafes isolées, assurez-vous qu' e lles sont suffisamment serrées pour maintenir
le fil électrique en place. Des agrafes trop serrées peuvent endommager les câbles et provoquer un
dysfonctionnement de la commande murale.
AVERTISSEMENT
!
L'utilisation d'une autre commande murale pourrait produire des résultats inattendus de la porte ainsi que le
dysfonctionnement de l'éclairage. Localisez la console murale en vue de la porte et suffisamment loin de la porte pour
éviter tout contact pendant l'utilisation de la console. La commande doit être à une hauteur minimale de 1,5 m au-dessus
du sol afin que les jeunes enfants ne puissent pas l'atteindre.
Striped Wire to B/W Terminal
White Wire to W Terminal
Warning Label inside
owners manual
B/W W
Wall Console Wires:
FIG. 13
15