BEFORE INSTALLING THE RANGE HOOD, CHECK FOR PHYSICAL DAMAGES.
THIS RANGE HOODS COMES WITH A WIRE AND PLUG.
If there is a grinding noise coming from the motor,
Advanced Preparations:
1. Read the entire installation guide and users manual thoroughly, understand instructions and
warnings.
2. Be familiar with the controls of the range hood.
3. Place the range hood on a flat, stable surface. Connect the range hood to a designated
standard outlet (please refer the product label for the suitable voltage of this unit) and verify
no debris has entered the vent openings, then turn on the range hood.
4. Place all supplied parts and required hardware on a flat, stable surface and verify the
existence of all supplied parts.
5. Carefully remove the white/blue plastic protective coat from the chimney covers and range
hood if any.
Preparations:
NOTE: To avoid damage to your hood, prevent debris from entering the vent opening.
1. Disconnect power cord, remove the stainless steel baffle filter and grease tunnel.
2. Set aside the stainless steel baffle filters and grease tunnel until the range hood is properly
installed.
12
| CYCLONE
PREPARATION
TEST THE HOOD BEFORE INSTALLATION.
contact us as soon as possible.
DO NOT INSTALL
IT,