Adjusting The Height Of Cut - Toro Z Master Professional 7500-D Series Operator's Manual

Adjusting the Height of Cut

The cutting height of the mower deck can be adjusted
from 2.54 cm to 14 cm (1 to 5-1/2 inches) in 6.4 mm
(1/4 inch) increments.
1. Park the machine on a level surface, disengage
the blade-control switch, and engage the parking
brake.
2. Press the top of deck-lift switch to raise the
center deck and wing decks.
3. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
4. Adjust the center deck by performing the
following procedure:
A. Remove the height-of-cut pin from the
deck-lift plate on the right side of the center
deck.
B. Insert the height-of-cut pin into the hole
corresponding to the desired cutting height.
See the decal on the side of the deck-lift
plate for the cutting heights.
5. Adjust the side wing decks by performing the
following procedure:
A. Ensure that the wing decks are locked in
place.
B. Unlock the cam locks located on the
height-of-cut channel on the wing deck
(Figure 27).
Figure 27
1. Cam lock
2. Height-of-cut pin
C. Remove the lynch pin from the height-of-cut
pin on both the front and rear channels.
D. Move the wing deck to the appropriate
height and install the height-of-cut pins and
lynch pins (Figure
g239055
3. Lynch pin
27).
E. Lock the cam lock.
F. Repeat for the other wing deck.
6. If you desire additional height-of-cut range,
adjust the front and rear gauge wheels on the
wing deck as follows:
A. Remove the mounting hardware from the
gauge wheel.
B. Adjust the front and rear gauge wheels
to the appropriate hole location (see the
chart below and
mounting hardware.
Hole Location
Top hole (-1 on the decal)
Middle hole (0 on the decal)
Bottom hole (+1 on the decal)
Height-of-cut range
1. Top hole (-1 on the decal)
2. Middle hole (0 on the decal)
3. Bottom hole (+1 on the decal)
C. Repeat for the other wing deck.
27
Figure 28) and install the
Height-of-Cut Range
25 to 89 mm (1 to 3-1/2 inches)
51 to 114 mm (2 to 4-1/2
inches)
76 to 140 mm (3 to 5-1/2
inches)
Figure 28
g212253