Mower Deck Maintenance; Leveling The Mower Deck - Toro Z Master Professional 7500-D Series Operator's Manual

Mower Deck
Maintenance

Leveling the Mower Deck

Setting up the Machine
Note:
Ensure that the mower deck is level before
matching the height of cut (HOC).
1. Park the machine on a level surface, disengage
the blade-control switch, and engage the parking
brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Check tire pressure of the drive tires.
If needed, adjust to 124 kPa (18 psi).
4. Position the mower to the 102 mm (4 inches)
height-of-cut position.
Leveling the Center Deck and
Wing Decks
1. Raise the center deck and fold the wings by
pressing down at the rear of the deck-lift switch.
Hold the switch down until both wings are
completely folded.
2. Position the mower to the 102 mm (4 inches)
height-of-cut position.
3. Unlock the left and right wing deck cam locks
(Figure 71).
4. Remove and retain the wing deck height-of-cut
lanyard (Figure 71).
Figure 71
1. Cam lock
2. Clevis pin
g239055
3. Lanyard
5. Insert the height-of-cut pin into the 102 mm (4
inches) location and install the lanyard.
6. Lock the each wing deck cam lock.
7. Start the engine.
Note:
The parking brake must be engaged and
the motion-control levers must be out to start
the engine. The operator does not have to be in
the seat. Ensure that all persons are clear of
the deck wings.
8. Press and hold the front of the deck-lift switch
until the center deck lowers and both wings are
completely unfolded to the cutting height.
9. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
10. Measure from the level surface to the front tip of
the left and right center deck blades
The measurement should read 102 mm (4
inches).
1. 108 mm (4-1/4 inches)
2. Rear blade tip
3. Front blade tip
4. 102 mm (4 inches)
5. Level surface
57
(Figure
Figure 72
72).
g239092