Adjusting the Tracking
1.
Park the machine on a level surface, disengage
the blade-control switch, and engage the parking
brake.
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Move the throttle midway between F
Slow.
4.
Move both motion-control levers all the way
forward until they both hit the stops in the T-slot.
5.
Check which way the machine tracks.
•
If it tracks to the right, loosen the bolts and
adjust the left stop plate rearward on the
left T-slot until the machine tracks straight
(Figure
50).
•
If it tracks to the left, loosen the bolts and
adjust the right stop plate rearward on the
right T-slot until the machine tracks straight
(Figure
50).
6.
Tighten the stop plate
Figure 50
1. Control lever
2. Bolt
7.
Align the levers in the front-to-rear position by
bringing the levers together to the N
position, and slide them until they are aligned,
then tighten the bolts
and
AST
(Figure
50).
3. Stop plate
EUTRAL
(Figure
51).
8.
If alignment is needed, loosen the 2
motion-control lever mounting bolts on the
misaligned side
g254284
9.
Move motion-control lever to meet the opposite
side.
10.
Tighten the 2 motion-control lever mounting
bolts
(Figure
45
Figure 51
(Figure
52).
Figure 52
52).
g009195
g254283