Table of Contents
Advertisement
NLTroubleshooting
Malfunction
There are removable
smudges on it
glasses, glassware with
a metallic appearance
and cutlery.
Rust marks on it
specifications.
There are detergent
residues inside
the detergent
tray or in the tablet
tray.
50
Cause and Troubleshooting
The amount of rinse aid is set too high.
Set the rinse system to a lower setting.
▶
→ "Setting the amount of rinse aid", page 27
No rinse aid has been added.
Add rinse aid.
▶
→ "Filling with rinse aid", page 26
Residues of detergent are present during the final rinse
part of the programme. Detergent dispenser lid was
blocked by dishes and did not open fully.
Arrange the dishes in the upper basket in such a way
1.
that the tablet tray is not blocked by dishes.
→ "Loading crockery", page 31
Pieces of crockery are blocking the lid of the
detergent dispenser.
Do not place any dishes or fragrance dispenser in the
2.
tablet tray.
Dishes have been pre-cleaned too well. The sensor
system therefore opts for a weak washing programme.
Some stubborn dirt cannot be removed.
Only remove coarse food residues and do not pre-
▶
rinse the dishes.
Cutlery is not sufficiently rust resistant. Knife blades
are often more strongly affected by this.
Use rust-resistant cutlery.
▶
Cutlery also rusts when it is washed together with
rusty objects.
Do not wash rusty objects.
▶
Salt content in the dishwater is too high.
Remove spilled softener salt from the rinse aid
1.
container.
Tightly close the lid of the softener salt container.
2.
The spray arms were blocked by dishes, preventing
the detergent from being rinsed away.
Make sure the spray arms are not blocked and can
▶
rotate freely.
Advertisement
Table of Contents
