Outline Design Of Positioning System - Mitsubishi Electric A1SD75P1-S3 User Manual

1 PRODUCT OUTLINE

1.1.4 Outline design of positioning system

The outline of the positioning system operation and design, using the AD75, is shown
below.
PLC CPU
Program
1) The AD75 output is a pulse train.
2) Simultaneously with the start of motor rotation by the speed command from the
3) When the command pulse output from the AD75 is stopped, the droop pulses in
4) As shown below, the pulse train is rough during motor acceleration, and is dense
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Positioning
module AD75
Forward run
pulse train
Set data
Reverse run
Write,
pulse train
read,
etc.
Write,
read, etc.
· SW1IVD-AD75P-E
· SW0D5C-AD75P-E
· AD75TU
Fig.1.2 Outline of the operation of positioning system using AD75
When the pulse train is output, the pulses are cumulated with the deviation
counter. This pulse droop amount is changed into a DC analog voltage by the D/A
converter, and is used as the speed command.
drive unit, feedback pulses proportional to the speed are generated by the pulse
encoder PLG, and the droop pulses in the deviation counter are subtracted.
The deviation counter maintains a set droop amount and the motor continues
rotating.
the deviation counter decreases, and the speed slows. When there are no more
droop pulses, the motor stops.
In other words, the motor rotation speed is proportional to the designated pulse
frequency, and the motor rotation angle is proportional to the No. of output
command pulses.
Thus, if the movement amount per pulse is specified, the motor can be fed to a
position proportional to the No. of pulses in the pulse train. The pulse frequency
will be the motor speed (feedrate).
at the full speed. During deceleration, the pulse train becomes rougher, and
finally the pulse reaches 0. The motor stops with a slight delay in respect to the
command pulse.
This time difference is required to ensure the stopping precision, and is called the
stop settling time.
Drive unit
Speed
command
D/A
Devia-
converter
tion
counter
Interface
Feedback pulse
1 - 8
MELSEC-A
Servomotor
Servo
M
amplifier
PLG