Delta CliQ II DRP024V060W1N Series Technical Data Sheet page 11

Din rail power supply 24 v 60 w 1 phase, nec class 2

Table of Contents

TECHNICAL DATASHEET

CliQ II DIN Rail Power Supply

24 V 60 W 1 Phase, NEC Class 2 / DRP024V060W1N□

Functions

Graph illustrating the Start-up Time, Rise Time, and Hold-up Time



Start-up Time

The time required for the output voltage to reach 90% of its final steady state set value, after the input voltage is applied.

Rise Time

The time required for the output voltage to change from 10% to 90% of its final steady state set value.

Hold-up Time

Time between the collapse of the AC input voltage, and the output falling to 95% of its steady state set value.

Inrush Current

Inrush current is the peak, instantaneous, input current measured

and, occurs when the input voltage is first applied. For AC input

voltages, the maximum peak value of inrush current will occur

during the first half cycle of the applied AC voltage. This peak value

decreases exponentially during subsequent cycles of AC voltage.

External Input Protection Device

The unit is protected at the L pin, with an internal fuse that cannot be replaced. The power supply has been tested and approved on 20 A

(UL) and 16 A (IEC) branch circuits without additional protection device. An external protection device is only required if the supplying

branch has an ampacity greater than above. Thus, if an external protective device is necessary, or, utilized, please refer a minimum value

of 16 A B- or 8 A C- characteristic breaker.

All parameters are specified at 25°C ambient and AC input unless otherwise indicated.

www.DeltaPSU.com (June 2021, Rev. 08)

Arrow.com.

Downloaded from

Dynamic Response

The power supply output voltage will remains within ±5% of its

steady state value, when subjected to a dynamic load from 0 to

100% of its rated current.

50% duty cycle / 5Hz to 1KHz



Table of Contents