Delta CliQ II DRP024V060W1N Series Technical Data Sheet page 10

TECHNICAL DATASHEET
CliQ II DIN Rail Power Supply
24 V 60 W 1 Phase, NEC Class 2 / DRP024V060W1N□
Safety Instructions
Vertical Mounting

• ALWAYS switch mains of input power OFF before connecting and disconnecting the input voltage to the unit. If mains are not turned
OFF, there is risk of explosion / severe damage.
To guarantee sufficient convection cooling, keep a distance of 50 mm (1.97 inch) above and below the device as well as a
•
lateral distance of 20 mm (0.79 inch) to other units.
Note that the enclosure of the device can become very hot depending on the surrounding air temperature and load of the power
•
supply. Risk of burns!
Only plug in and unplug connectors when power is turned off!
•
DO NOT insert any objects into the unit.
•
Hazardous voltages may be present for up to 5 minutes after the input mains voltage is disconnected. Do not touch the unit during
•
this time.
The power supplies are built in units and must be installed in a cabinet or room (condensation free environment and indoor location)
•
that is relatively free of conductive contaminants.
CAUTION: "For use in a controlled environment".
•
For DRP024V060W1NY:
The power supplies unit must be installed in an IP54 enclosure or cabinet in the final installation. The enclosure or cabinet must
•
comply with EN 60079-0 or EN 60079-15.
Warning: Explosion Hazard - Substitution of components may impair suitability for Class I, Division 2.
•
Warning: Explosion Hazard - Do not disconnect equipment or adjust potentiometer unless the power has been switched off or the
•
area is known to be non-hazardous.
All parameters are specified at 25°C ambient and AC input unless otherwise indicated.
10
www.DeltaPSU.com (June 2021, Rev. 08)
Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com.
Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from
Horizontal Mounting
