Table of Contents
Advertisement
Table 1 Error codes
Error code
Symptoms
The machine has shut
down because it has
overheated.
36
37
No coolant flow
266
Impossible to have full
range of configurable
parameters
If for any reason you are unable to perform the recommended actions in the event of a fault, contact the nearest authorized
Lincoln Electric service facility.
Cause
System detected a temperature
level beyond the normal system
operating limit.
There is no coolant flow in the
cooler after 3 seconds of welding.
Limit & Lockout features are
possibly activated for selected
memory.
WARNING
18
Recommended Course of Action
Be sure process does not exceed duty
cycle limit of the machine.
Check the setup for proper air flow around
and through the system.
Check that the system has been properly
maintained,
including
accumulated dust and dirt from the intake
and outlet louvers.
User interface show information when
machine will be cooled down. To continue
welding operation Please press Left
Control or start welding operation by the
torch trigger.
Make sure there is enough coolant in the
tank and that auxiliary power is supplied.
Make sure the pump is working. When the
trigger is pulled the pump should run.
Check cooling circuit connections.
Unselect memories
Change Limits value
removal
of
Advertisement
Table of Contents
