KTM 450 EXC-F Six Days 2019 Setup Instructions page 16

2 SETUP
14
–
Mount and tighten screw
Guideline
Remaining screws,
chassis
–
Mount and tighten screw
Guideline
Remaining screws,
chassis
–
Mount and tighten screw
tact disk.
Guideline
Remaining screws,
chassis
E00489-10
–
Connect the tail light plug-in connector to the main wiring
harness plug-in connector.
–
Mount the engine control unit on the holder.
Info
The wiring harness runs under the engine control
unit.
E00498-10
–
Position the main silencer. Mount screws
washers, but do not tighten yet.
–
Attach spring
Spring hook (5030501700004)
–
Tighten screws
Guideline
Remaining screws,
chassis
E00487-10
–
Attach the side cover in area
–
Mount and tighten screw
Guideline
Screw, sub-
frame
–
Mount and tighten screw
Guideline
Remaining screws,
E00494-10
chassis
–
Install the battery. (
–
Install the fuel tank. (
bl
with the collar bushing.
M6 10 Nm (7.4 lbf ft)
bm
.
M6 10 Nm (7.4 lbf ft)
bn
with negative cable and con-
M6 10 Nm (7.4 lbf ft)
9
8
.
9
.
M6 10 Nm (7.4 lbf ft)
A
and engage it in area
7
.
M8 35 Nm (25.8 lbf ft)
6
.
M6 10 Nm (7.4 lbf ft)
p. 28)
p. 32)
with the
B
.
Loctite ® 2701™