–
Connect plug-in connector of the headlight.
–
Connect plug-in connector of the turn signal switch.
–
Secure turn signal relay
the connector.
–
Install the headlight mask with the headlight. (
–
Route the turn signal cable harness from the front to the
rear as far as the battery compartment.
–
Position and secure the turn signal cable harness using
cable ties on the main wiring harness under the rubber
straps of fuel tank support.
S01418-01
–
Remove screw
–
Remove screw
–
Pull off the side cover in area
it toward the rear.
E00494-10
–
Detach spring
Spring hook (5030501700004)
–
Remove screws
silencer.
E00487-10
–
Pull off the engine control unit from the holder and hang to
the side.
–
Disconnect plug-in connector
and take off.
–
Join the turn signal cable harness plug-in connector to the
main wiring harness plug-in connector.
S01417-10
5
with a cable tie and plug in
6
.
7
.
A
and area
8
.
9
with the washers and take off the main
bk
on main wiring harness
SETUP 2
p. 20)
B
and remove
11