KTM 450 EXC-F Six Days 2019 Setup Instructions page 15

–
Route the turn signal cable harness toward the rear and
pass through the frame paying attention to the plugs as
you do so.
–
Route turn signal cable harness on the license plate holder
and pass turn signal cable harness through the drill hole.
–
Position tail light on license plate holder, and mount and
tighten screws
E00492-10
–
Carefully pass the tail light cable through the frame, pay-
ing attention to the plug as you do so.
–
Position the license plate holder on the rear.
–
Mount and tighten screws
E00495-10
bp
.
bo
.
SETUP 2
13