Table of Contents
Advertisement
Top Component Removal and Installation
Display Installation (continued)
DISPLAY INSTALLATION
After installing the display, install:
Control board
1
Panel assembly
2
Then
install the unit
.
Install the Display
1
Place the bottom of the display into the channel on the
control board bracket.
2
Press the top of the display into place.
Install the Control Board
1
Place the bottom of the control board into the control board
bracket supports.
2
Push the top of the control board into the control board
bracket.
3
Insert the ribbon cable into the ribbon cable connector and
lock the ribbon cable connector.
4
Connect the wire connectors to the control board.
Install the Top Plate
1
Place the top plate on the unit.
2
Use a T-20 Torx bit to install the screws into the top plate.
CONTROL PANEL REMOVAL
To remove the control panel, first remove the water tank, top
plate, tank housing cover, valve assembly, tank housing base,
control board, and display.
827703 REV B.1
CSO (SWS #13543126)
Remove the Water Tank
1
Touch Water on the control panel.
2
Remove the water tank from the unit.
Remove the Top Plate
1
Use a T-20 Torx bit to remove the screws from the top and
back of the unit.
2
Remove the top plate from the unit.
Remove the Tank Housing Cover
1
Remove the wire guides from the tank housing cover.
2
Use a T-10 Torx bit to remove the screws from the tank
housing cover.
61
service.subzero.com
Advertisement
Table of Contents
