Table of Contents
Advertisement
Top Component Removal and Installation
REMOVE THE VALVE ASSEMBLY (continued)
2
Remove the wire connectors from the water valve.
3
Remove the ground wires.
4
Remove the drive motor tab from the tank housing cover.
5
Use a T-10 Torx bit to remove the screws from the valve
assembly.
6
Remove the valve assembly from the unit.
VALVE ASSEMBLY INSTALLATION
After installing the valve assembly, install:
1
Top plate
2
Unit
Water tank
3
Install the Valve Assembly
1
Place the valve assembly into the tank housing base.
2
Use a T-10 Torx bit to install the screws into the valve
assembly.
3
Install the drive motor tab into the notch in the tank housing
cover.
4
Connect the ground wires.
5
Connect the valve assembly wire connectors.
6
Connect the water tank microswitch wire connectors.
TANK HOUSING COVER REMOVAL
To remove the tank housing cover, first remove:
Water tank
1
2
Unit
3
Top plate
827703 REV B.1
CSO (SWS #13543126)
Remove the Tank Housing Cover
1
Remove the wire guides from the tank housing cover.
2
Use a T-10 Torx bit to remove the screws from the tank
housing cover.
3
Remove the tank housing cover from the unit.
TANK HOUSING COVER INSTALLATION
After installing the tank housing cover, install:
1
Top plate
Unit
2
Water tank
3
Install the Tank Housing Cover
1
Place the tank housing cover onto the tank housing base.
2
Use a T-10 Torx bit to install the screws into the tank
housing cover.
3
Install the wire harness clips onto the tank housing cover.
TANK HOUSING BASE REMOVAL
To remove the tank housing base, first remove:
Water tank
1
Unit
2
Top plate
3
Valve assembly
4
5
Tank housing cover
Remove the Tank Housing Base
1
Use a T-20 Torx bit to remove the screws from the side of
the tank housing base.
2
Push the tank housing base forward out of the control
panel.
58
service.subzero.com
Advertisement
Table of Contents
