Removing A Memory Module - Toshiba Satellite Pro A120-106 User Manual

Removing a memory module

To remove the memory module, make sure the computer is in boot mode
then:
1. Set the computer to boot mode and turn the computer's power off.
Make sure the Power indicator is off.
2. Remove AC adaptor and all cables connected to the computer.
3. Turn the computer upside down and remove the battery pack. Refer to
Replacing the battery pack
Modes, for details.
4. Loosen the screw securing the memory module cover. The screw is
attached to the cover to prevent it from being lost.
5. Insert your fingernail or a thin and flat object into the slit and lift it off.
6. Push the latches to the outside to release the module. A spring will
force one end of the module up.
7. Grasp the module by the sides and pull it out.
■
If you use the computer for a long time, the memory modules and the
circuits located close to the memory modules will become hot. In this
case, let them cool to room temperature before you replace them.
■
Do not touch the connectors on the memory module or on the
computer. Debris on the connectors may cause memory access
problems.
8. Seat the memory module cover and secure it with one screw.
Be sure that the cover is closed firmly.
9. Install the battery pack. Refer to
Chapter 6,
10. Turn your computer over.
User's Manual
section in Chapter 6,
Figure 8-8 Removing the memory module
Power and Power-Up
Power and Power-Up
Latches
Replacing the battery pack
Modes, for details.
Optional Devices
section in
8-9