Writing Cds On Dvd-Rom&Cd-R/Rw Drive - Toshiba Satellite Pro A120-106 User Manual

Operating Basics
3. Push the center of the disc tray to close it. Press gently until it locks into
place.
How to remove CD/DVD when the disc tray will not open
Pressing the eject button will not open the disc tray when the computer
power is off. If the power is off, you can open the disc tray by inserting a
slender object (about 15 mm) such as a straightened paper clip into the
eject hole just to the right of the eject button.
Turn off the power before you use the eject hole. If the CD/DVD is spinning
when you open the disc tray, the CD/DVD could fly off the spindle and
cause injury.
Writing CDs on DVD-ROM&CD-R/RW drive
Depending on the type of drive installed, you may be able to write CDs. The
DVD-ROM&CD-R/RW drive lets you write as well as read CD-ROMs.
Observe the precautions in this section to ensure the best performance for
writing CDs. For information on loading and unloading CDs refer to the
Using optical disk drives
■
Refer to the
writable CD/DVD discs.
When writing to media using an optical drive, always connect the AC
adaptor to a power plug socket or power source to ensure maximum
performance. If data is written powered by the batteries, writing may
sometimes fail due to low battery power and data loss may occur.
4-6
Figure 4-9 Manual release with the eject hole
section.
Writable discs, Chapter 2 for details about the types of
15mm
Eject hole
User's Manual