Table of Contents
Advertisement
Electronic Temperature Control (cont.)
Change Defrost Intervals
The defrost interval is the duration between defrost cycles,
NOTICE ›
The defrost interval can only be changed if the
defrost mode parameter dFm is set for tim or Fro.
1. Press and hold both info
display shows hSt.
2. Press the up arrow
3. Press and hold info until the display shows the current
defrost interval time.
4. While holding info, the up or down
the setting.
5. Release all buttons and wait for the control to display the
current appliance temperature.
TEC_TM_158 | REV. B | EN
L A E C O N T R O L L E G E N D
and cancel
until the
until the display shows dFt.
DO NOT RELEASE THE BUTTON!
arrows to adjust
GDM-HST02
Compressor Running
Evaporator Fan Running
Appliance in Defrost
Activation of 2
Alarm
Change Display Readout
The display can show the temperature in either Fahrenheit or
Celsius.
Press cancel
options.
• °F: Fahrenheit (no decimal)
• 1°C: Celsius (0.1 precision)
• 2°C: Celsius (no decimal)
Fahrenheit
12/4/2023
Info/Set Point
nd
Parameter Set
Manual Defrost/
Down Arrow
to cycle through the display readout
Celsius (0.1 precision)
Celsius
truemfg.com
Manual Activation/
Up Arrow
Stand-By/
Cancel
Page 33 of 48
Advertisement
Table of Contents
