Table of Contents
Advertisement
Installation & Setup (cont.)
Procedure – 6" (152 mm) Leveling Legs
1. Access the appliance bottom.
2. If present, remove the leveling screws.
3. Thread the leveling legs into the frame rail or appliance
bottom. See figs. 4 and 5.
4. Verify that the appliance is level. See "Level the Appliance"
(pg. 19).
5. If the appliance is not level, gently lift and support the low end
of the appliance. Then, with an adjustable wrench, screw the
leveling leg bottom stems in or out to level and support the
appliance. See fig. 4 and 6.
Rail End
Snug Fit
Here
Fig. 4. Leveling leg diagram.
Fig. 5. Screw the leveling legs into the threaded holes.
Fig. 6. Turn the bottom stem to level the appliance.
Page 18 of 48
Lower Rail Assembly
Bottom Stem
GDM-HST02
Procedure — Castors
Install castors with brakes in the front.
1. Access the appliance bottom.
2. If present, remove the leveling screws.
3. Thread the castors into the frame rail or appliance bottom.
See figs. 7 and 8.
4. Verify the appliance is level. See "Level the Appliance" (pg. 19).
5. On the low end of the appliance, loosen the castor bolt
enough to slide provided castor shims between the castor
bearing and the bottom rail of the appliance. See fig. 9.
6. Install the desired number of shims. See fig. 9.
• If more than one shim is used, be sure shim slots are offset.
See fig. 10.
• DO NOT use more than four (4) shims on a castor.
• Be sure each shim touches the castor stem.
7. Tighten and secure the shims and castors.
8. Verify the appliance is level.
9. If the appliance is not level, repeat the steps 3 – 6 until the
appliance is level and supported.
Lower Rail Assembly
Rail End
Snug Fit
Here
Bearing
Race
Castor
Fig. 7. Castor diagram.
Fig. 9. Insert the castor shim(s). be sure
to tighten the castor stem.
12/4/2023
USER ACTION!
Castor
Stem
Leveling
Shim
Fig. 8. Screw the castors into the
threaded holes.
Fig. 10. Install multiple shims with offset
slots.
P#840669
TEC_TM_158 | REV. B | EN
truemfg.com
Advertisement
Table of Contents
