True GDM-HST02-HC-TSL01 Installation Manual page 16

Installation & Setup (cont.)
Procedure
1. Remove the outer packaging (cardboard and bubble wrap
or Styrofoam corner and clear plastic). See fig. 1. Inspect for
concealed damage. Again, immediately file a claim with the
freight carrier if there is damage.
NOTICE ›
DO NOT remove the shipping bracket (fig. 2) until
the appliance is installed in its final location. Do not discard;
use the bracket/blocks when next moving the appliance.
2. With an adjustable wrench, remove all shipping bolts securing
the wood skid to the bottom of the appliance. See fig. 3.
NOTICE ›
Move the appliance as close as possible to the
final location before removing the wooden skid. Some models
may require removing the front and/or rear grill/cover to access
the shipping bolts.
3. If leveling legs or castors will not be used, remove the
appliance from the wood skid and set the skid aside.
NOTICE ›
DO NOT lift the appliance by the counter tops,
doors, drawers, or grills.
If leveling legs or castors will be used, rotate the appliance
on the skid (see fig. 4) and see the installation instructions
on pg. 15.
NOTICE ›
Remember to leave appliance upright for 24
hours before plugging into a power source. The override key
is shipped zip-tied to the door handle.
Fig. 3. Shipping bolt locations.
Page 16 of 48
GDM-HST02
Fig. 1. Remove the exterior packaging.
Fig. 2. Remove the glass swing door shipping bracket, if so equipped. Do not
discard.
Fig. 4. When lifting unit, do not use countertops, doors/drawers, or grills as a lifting
point.
12/4/2023 P#840669 TEC_TM_158 | REV. B | EN
truemfg.com