Kenwood KRC-685R Instruction Manual page 41

Installation
@ Removing the Unit
1 Refer to the section "Removing the hard rubber frame" (See
'page 40) and then remove the hard rubber frame.
2 Remove the Hex-head screw with integral washer (M4x8) on
the back panel. ;
3 Insert the two removal tools deeply into the slots on each side,
as shown.
Accessory® Catch facing up
4 Lower the removal too!
toward the bottom, and pull
out the unit halfway whilst
pressing towards the
inside.
Be careful to avoid injury from the catch pins on the removal tool.
5 Pull the unit all the way out
with your hands, being
careful not to drop it.
8 Installing in Japanese-Made Cars
1 Refer to the section "Removing the hard rubber frame" and
then remove the hard rubber frame.
2 Align the holes in the unit (two locations on each side) with the
vehicle mounting bracket and secure the unit with the
accessory screws.
T: Toyota cars
N: Nissan cars
* Do not use your own screws. Use only the screws provided. If
- you use the wrong screws, you could damage the unit.
* Damage may occur if a screwdriver or similar tool is used with
excessive force during the installations.
Accessory@)...for Nissan car
Accessory© ...for Toyota car
@ Screwing the Faceplate on the Unit
If you want to fasten the faceplate to the main unit so that it
does not fall off, insert the provided screws (#2.6 x 12mm) in
the holes as follows.
Hole!
1 Insert one of the provided Hew 2 eee Sa
screws into hole @ so that the
screw is perpendicular to the
bottom panel of the unit.
2 Similarly, insert another provided
screw into hole @.
Ensure that the faceplate is fixed firmly before operating this unit.
Never insert the taptite screws (#2.6 x 12 mm) in any other screw
holes than the one specified. If you insert it in another hole, it will
contract and may cause damage to the mechanical parts inside the
unit.
—A,—