Burner Mounting Plate / Burner Adapter Plate - Burnham V9A Series Installation, Operating And Service Instructions

b. Use the left side panel and right side panel usage
charts to determine correct positions of side
panels. The three (3) digit panel identification
numbers shown in the charts are also stamped
along the bottom edge of each panel. Refer to
Figures 17 and 18.
c. Rearward and Intermediate panels have reverse
bend flanges on one side of panel. These panels
must be installed prior to forward panels.
To install multiple side panels, start at the rear of
boiler and work forward. To remove panels, reverse
order of assembly.
Pour installer plusieurs panneaux latéraux,
commencez par l'arrière de la chaudière et
avancez. Pour retirer les panneaux, inversez l'ordre
d'assemblage.
d. If boiler is equipped with tankless heaters they
should be installed at this time if they were not
installed for hydrostatic test outlined on Page 24.
e. Install right side panels into position by inserting
top of panel into 'U' shaped channel, pushing
bottom of panel in toward boiler, and sliding
panel down into 'J' shaped channel. Repeat
procedure until all right side panels are in place.
Figure 20: Burner Mounting Plate/Burner Adapter Plate Options
f. Remove the knockouts necessary for tankless
heater operation on left side panels.
g. Install left side panels, using the same procedure
used to install the right side panels.
8. Combination Label and Burnham Logo Plate were
attached to jacket front panel at time of manufacture.
If loose or peeling, apply pressure to reset adhesive.
9. Tighten all sheet metal screws to complete jacket
assembly.
BURNER MOUNTING PLATE - Refer to Figures 13
F.
and 20.
1. Using silastic sealant, secure the 3/16" diameter
rope gasket to the groove along the mounting plate
opening in the front section.
2. Install 5/16" x 1" lg. cap screw in lower tapping on
front section to carry weight of burner mounting
plate.
3. Engage bottom slot on burner mounting plate with
matching bolt in bottom tapping of front section.
Align mounting holes and fasten the mounting plate
to the boiler sections with seven (7) remaining 5/16"
cap screws and washers. Fully tighten all bolts.
G.
MOUNT BURNER ADAPTER PLATE TO
BURNER MOUNTING PLATE.
Refer to Figures 13 and 20. ALSO, REFER TO
BURNER INSTALLATION MANUAL FOR
INSTRUCTIONS SPECIFIC TO EACH BURNER.
31