Burner Mounting Plate / Burner Adapter Plate - Burnham V11 Series Installation, Operating And Service Instructions

11. Combination Label and Burnham Logo Plate
applied by manufacturer. If loose or peeling, apply
pressure to reset adhesive.
12. Place the rating label (from Instruction envelope)
over the top of front panel label that identifies the
proper location.
13. On steam boilers, attach lowest permissible water
level plate (from steam trim carton) to the front
panel using sheet metal screws.
14. Tighten all sheet metal screws to complete jacket
assembly.
G.
MOUNT BURNER MOUNTING PLATE, refer to
Figures 15 and 26.
1. Install ten (10) 5/16" x 2" long tap-end studs with
the short length of threads into the boiler front
section.
2. With the use of silastic, secure the 3/16" diameter
rope gasket to the groove along the mounting plate
opening in the front section.
3. Place burner mounting plate over studs and secure
with 5/16" flat washer, lock washers and brass nuts.
H.
MOUNT BURNER ADAPTER PLATE TO
BURNER MOUNTING PLATE, refer to Figures 26
and 27.
Figure 2: Burner Mounting Plate/Burner Adapter Plate Options
Figure 26: Burner Mounting Plate and Burner
0
Adapter Plate