IF REMOVING AN EXISTING TOILET
1
Turn off water
supply
INSTALLATION INSTRUCTIONS
BACK-TO-BACK INSTALLATION
Depending upon your plumbing and venting conditions, the flow from this toilet
in a back-to-back installation may create a vacuum on the system and draw water
from the opposing bowl. The National Standards Plumbing Code prohibits the
use of a cross fitting for drainage as throw over is possible. The code does
approve a directional "Y" style fitting with proper venting to direct the water
downward and away from the other toilet.
7302155-100 Rev. E (6/23)
2
Flush to remove water from
tank; sponge remaining
water from bowl before
removing toilet
Recommended fitting type for
back-to-back installations.
3
Clean flange
CAUTION
If leaving floor flange
open for more than 1-2
hours, cover flange to
prevent escaping sewer
gasses.