Schwinn AD2i Assembly Manual page 26

Console shuts off (enters sleep
mode) while in use
Unit rocks/does not sit level
Pedals loose/unit difficult to
pedal
Clicking sound when pedaling
Seat post movement
26
Check RPM Sensor (requires
shroud removal)
Check data cable integrity
Check data cable
connections/orientation
Check magnet position (re-
quires shroud removal)
Check RPM Sensor
Check leveler adjustment
Check surface under unit
Check pedal to crank connec-
tion
Check crank to axle connection Crank should be tightened
Check pedal to crank connec-
tion
Check locking pin
Check adjustment knob
RPM sensor should be aligned
with magnet and connected
to data cable. Realign sensor
if necessary. Replace if there is
any damage to the sensor or
the connecting wire.
All wires in the cable should be
intact. If any are cut or crimped,
replace cable.
Be sure cable is connected
securely and oriented prop-
erly. Small latch on connector
should line up and snap into
place.
Magnet should be in place on
pulley.
Contact Customer Care for
further assistance.
Leveling feet may be turned in
or out to level bike.
Adjustment may not be able
to compensate for extremely
uneven surfaces. Move bike to
level area.
Pedal should be tightened
securely to crank. Be sure con-
nection is not cross-threaded.
securely to axle.
Remove pedals and reattach
fully.
Be sure adjustment pin is
locked into one of the seat post
adjustment holes.
Be sure knob is securely tight-
ened.