State-Based Softkeys - Mitel 6873i User Manual

CONFIGURING SOFTKEYS

STATE-BASED SOFTKEYS

On the 6873i's bottom softkeys, you can configure a specific state to display when a softkey is being used.
The following table describes the states available to configure for the softkeys.
STATE
Idle
Connected
Incoming
Outgoing
Busy
The following table identifies the applicable default states for each softkey type on the IP phone.
SOFTKEY TYPE
None
Speed Dial
DND
XML
DESCRIPTION
The phone is not being used.
The current line is in an active call (or the call is
on hold).
The phone is ringing.
The user is dialing a number, or the far-end is
ringing.
The current line is busy because the line is in use
or the line is set as DND.
DEFAULT STATES
All states disabled.
Idle, Connected, Incoming, Outgoing, Busy
Idle, Connected, Incoming, Outgoing, Busy
Idle, Connected, Incoming, Outgoing, Busy
STATE-BASED SOFTKEYS
79