Table of Contents
Advertisement
1
2
4
2
3
4
Change filter elements:
Close the fuel cocks on the tank or cut off the flow of
fuel with the knob (1) for the filter insert to change if
running.
3
WARNING! Working on or approaching a run-
ning engine is a safety hazard. Beware of rotat-
ing parts and hot surfaces.
1. Place a receptacle under the filter.
2. Undo the T-bolt (2) and remove the cover (3).
3. Take out the insert carefully while turning it.
4. Drain off water and contaminants through the
drain plug (4).
5. Fit a new filter insert and fill the container with
clean fuel.
IMPORTANT! Cleanliness! No contaminants
must be allowed in the fuel system.
6. Change the gasket on the cover and the O-ring on
the T-bolt. Moisten the gasket and O-ring with fuel
before assembling.
7. Fit the cover and tighten it by hand.
8. Wipe off any fuel from the heat shield.
9. Dual filter: Change the other filter insert in the
same way.
10.Open the fuel cocks and put the knob (1) in posi-
tion for normal running. Make sure there are no
leaks.
Maintenance: Fuel system
53
Advertisement
Chapters
Table of Contents
