Volvo Penta TAMD74A-A Operator's Manual page 16

Control panel
14
Autostop
Alarms and messages from the control unit are con-
firmed by pushing the ACKNOWLEDGE button. This
must be done to enable restarting the engine after
autostop.
Lamptest
To make sure that the LEDs on the control panel are
working, push the LAMPTEST button. All working
LEDs on the panel are lit up. Six LEDs should be lit
during lamptest.
Log
The LOG button is pushed to show a log over recent
events. To scroll through this log list, use the UP and
DOWN buttons. To stop viewing the log list and return
to the previous view, push the CHANGE VIEW but-
ton.
Changing view
The instrument view is the main view of the control
panel. It shows selected readings from the switches
and senders on the engine. Changing between the
four available views on the LCD screen is done utiliz-
ing the CHANGE VIEW button. To change from in-
strument view to alarm list, the CHANGE VIEW but-
ton is pushed. The same operation is done to change
back to the instrument view.
The information view is displayed by pushing the
CHANGE VIEW button for one second. To change
back from information view to instrument view, the
CHANGE VIEW button is pushed briefly.
For log view, please refer to chapter "Log", above.