National Instruments PXI-6031E User Manual page 155

Replacing the DAQPad-6015/6016 Fuse
© National Instruments Corporation
The DAQPad-6015/6016 devices have a replaceable F 2 A 250 V
(5 × 20 mm) fuse. To remove the fuse from the DAQPad-6015/6016, loosen
the four flathead Phillips screws that attach the back lid to the enclosure,
and remove the lid as shown in Figure A-16. The fuse is located between
the power connector and switch near the back of the device.
N A
T I O
I N S
N A
T R
U M L
E N
T S
Figure A-16. DAQPad-6015/6016 Fuse Removal
To remove the fuse from the DAQPad-6015 BNC or mass termination
devices, loosen the eight flathead Phillips screws that attach the lid to the
enclosure, and remove the lid. The DAQPad-6015 mass termination device
is shown in Figure A-17. The procedure for removing the lid from the
DAQPad-6015 BNC is the same.
Appendix A
1 6
I n p
M u u t s D A
l t i f u , 1 6
Q P
n c t - b i t
a d
i o n - 6 0
, 2 0
1 5
I / O 0 k
f o r S / s
U S
B
A-19
Device-Specific Information
E Series User Manual