CDA HN6013FR Installation - Use - Maintenance page 35

Problem
After turning on, the
appliance turns itself
off.
The cooking zone has
turned itself off.
Noises are heard
during cooking.
The "h" or "H" symbol
is shown on the
cooking zone display.
F0 is shown on the
cooking zone display.
F1 is shown on the
cooking zone display.
F2 is shown on the
cooking zone display.
F3 is shown on the
cooking zone display.
F4 , F5, F6, F7, F8 or F9
is displayed on the
cooking zone display.
Cracked ceramic plate
Possible Cause
You have not used
any appliance
function.
The maximum operat-
ing time has been
reached.
Normal operation of the appliance. The noises emitted
depend on the pots used and the heat setting.
Normal operation of the appliance. The "h" or "H" symbols
indicate that the cooking zone is warm/hot and extra care is
required.
Supplied voltage too
low.
Supplied voltage too
high.
Electronic protection
has been activated.
The cooking zone
protection has been
activated.
External power
interference.
Danger! Immediately unplug the appliance from the power sup-
ply or disconnect the miniature circuit breaker (MCB) or fuse
in your home electrical distribution box. Refer the repair to the
nearest service centre.
Remedy
When turn on the appliance, use it
without delay.
Activate the cooking zone again and
set the heat setting.
Contact your electricity supplier.
Contact your electricity supplier.
Check that the cooling fan opening is
not obstructed.
Remove the cookware from the cook-
ing zone and wait until the F3 symbol
goes off.
Unplug the appliance from the power
outlet for 120 seconds or disconnect
the miniature circuit breaker (MCB) or
fuse in your home electrical
distribution
box.
35