Assembly of the gasket
If the seal has not been fitted at the
factory, proceed as follows:Before
installing the hob in the cut-out worktop,
the gasket is to be attached to the back of
the hob.To do this, first peel off the
protective film from the self-adhesive seal
and glue the gasket as close as possible to
the outer edge of the hob (fig 4).
Important Notes!
Do not position this appliance above a refrigeration unit. The heat
•
generated may cause the refrigeration unit to fail.
Do not position this appliance above a dishwasher or similar unit.
•
The moisture generated may cause serious issues.
This appliance is designed to be installed into and around cabinet
•
units and in worktop capable of withstanding temperatures of
100°C+.
Never place perishable foods, cleaning products or flammable
•
items in the cupboard below the appliance.
If an oven is to be installed below the hob, the thermal safety
•
system on the hob may not allow the hob to be used at the same
time as a pyrolytic programme on the oven.
If the hob is to be located above a working drawer, we
•
recommend that the drawer is not used for storing soft items,
for example dusters or towels; this is to minimize the risk of the
cooling system air intakes being obstructed.
31