Table of Contents
Advertisement
6.12 ASSEMBLY OF UPPER EXHAUST WITH CONCENTRIC KIT (LIFE 9 - CRISTAL PLUS 9 - ICON PLUS
9 - STEEL 9)
The stove is designed to have the upper exhaust with concentric using a dedicated kit.
The upper exhaust with concentric pipe requires 1 kit code 5022003 (optional).
To assemble the kit, proceed as follows:
• Remove the right side panel (see dedicated chapter).
• Undo the clamps and remove the combustion air flexible hose (see Fig. 43).
• Remove the rear cap near the smoke outlets (see Fig. 44).
• Fold the upper exhaust support tabs down (see Fig. 45).
Fig. 43 - Remove the flexible hose
Fig. 44 - Remove the cap
Fig. 45 - Fold the tabs
• Take the kit (see Fig. 46) and couple the pipe to the outlet of the smoke outlet of the stove (see Fig. 47).
• Fix the pipe to the support with the clamp provided (see Fig. 48).
Fig. 46 - Upper exhaust with concentric kit
Fig. 47 - Insert pipe d.80 mm
Fig. 48 - Block with clamp
• Remove the precut ring near the combustion air pipe (see Fig. 49).
• Insert the flexible hose in the hole (see Fig. 50) and connect it to the combustion air sleeve (see Fig. 51).
20
CRISTAL 9 - CRISTAL PLUS 9 - ICON PLUS 9 - AMARANTO 9 - LIFE 9 - STEEL 9 - ELANE 9
Advertisement
Table of Contents
