Table of Contents
Advertisement
4. Do not pinch the Wires (119, 120) during
this step. With the help of a second person,
hold the handrail assembly (D) on the Left and
Right Uprights (113, 114). Attach the handrail
assembly with four 3/8" x 2 3/4" Screws (2)
and four 3/8" Star Washers (9); start all four
Screws, and then tighten them.
Next, connect the Handrail Wire (119) to the
Upright Wire (120). The connectors should
slide together easily and snap into place
with an audible click. If they do not, turn one
connector and try again. Then, insert the wires
into the Right Upright (114).
5. Identify the Right Inner Console Base Cover
(105). Note: The Right Inner Console Base
Cover may be preassembled. If it is, go to
step 6.
Insert the edge (Q) of the Right Inner Console
Base Cover (105) under the edge of the Right
Upright Inner Cover (104) as you press the Right
Inner Console Base Cover against the handrail
assembly (D).
See the inset drawing. Make sure that the
wires (119, 120) are inserted above the indi-
cated boss (R) and under the three indicated
bosses (N).
Attach the Right Inner Console Base Cover
(105) with two #8 x 3/4" Screws (4); start both
Screws, and then tighten them. Do not over-
tighten the Screws.
Attach the Left Inner Console Base Cover
(not shown) to the left side of the handrail
assembly (D) in the same way. Note: There is
not a wire on the left side.
4
2
9
113
5
105
Side View
10
D
2
9
119
120
114
4
D
4
104
Q
R
119,
120
N
Advertisement
Table of Contents
