Table of Contents
Advertisement
What to Do?
To remove, follow the procedure below.
How to remove the operation guide
1
Remove the cover on the left side of the main unit, and fl ip the power
switch to "OFF".
(Page 13)
2
Remove the remote control from the hanger.
(Page 12)
3
Remove the hanger and
operation guide.
4
Screw the hanger on the wall.
5
Mount the remote control in the hanger.
6
Flip the power switch to ON.
• The "Power" LED lights up.
7
Reinstall the cover.
(Page 25)
■To install back the operation guide, follow the procedure above.
(Install the operation guide at step
38
Removal of Operation Guide
Screw
Phillips screwdriver
Hanger
Operation guide
(Page 13)
4
.)
Troubleshooting
First, try the actions described on pages 39 to 42.
If the problem persists, consult the installer, seller, or
TOTO customer service (see contact information on the
back cover).
Please check fi rst
Is the breaker on the distribution board turned on?
Check whether there is a power outage or the breaker has turned "OFF".
Is the Power LED lit?
Is the power switch fl ipped to "OFF"?
Flip it to "ON". (Page 13 Step 2-2)
Is the "Power ON/OFF" setting "OFF"?
Switch it to "ON" with the remote control. (Page 13 Step 2-2)
While the LED is lit, energy saver
so the toilet seat temperature may be reduced or the
Is the Energy saver
heater may be turned off.
LED lit?
Is the "
backside of the remote
Is the remote
controller fl ashing?
control working?
Replace the batteries. (Pages 34)
Is the remote control
transmitter or the remote
control receiver blocked?
Remove obstructions, dirt, water
droplets or any other blockages.
Remote control
CAUTION
If a water leak occurs, close the shutoff
valve.
is in operation,
(Page 20)
" LED on the
The remote control
batteries
uses
to operate.
Remote control
receiver
transmitter
39
Advertisement
Table of Contents
