Table of Contents
Advertisement
What to Do?
Follow the procedure below.
How to remove the operation guide
1
switch to "OFF".
(Page 13)
2
Remove the remote control from the hanger.
(Page 12)
3
Remove the hanger and
operation guide.
4
Screw the hanger on the wall.
5
Mount the remote control in the hanger.
Flip the power switch to ON.
• The "Power" LED lights up.
Reinstall the cover.
(Page 29)
To install back the operation guide, follow the procedure above.
(Install the operation guide at step
60
Removal of Operation Guide
Phillips screwdriver
Screw
Hanger
Operation guide
(Page 13)
.)
4
Troubleshooting
First, try the actions described on pages 61 - 67. If the problem persists, consult the installer, seller, or TOTO
customer service (see contact information on the back cover).
Is the breaker on the distribution board turned on?
Check whether there is a power outage or the breaker has turned "OFF".
Is the Power LED lit?
Flip it to "ON". (Page 13 Step 2-2)
Switch it to "ON" with the remote control. (Page 13 Step 2-2)
While the LED is lit, energy saver
so the toilet seat temperature may be reduced or the
Is the Energy saver
heater may be turned off.
LED lit?
Does the display screen
on the back of the remote
Is the remote
show "
control working?
Replace the batteries. (Pages 12, 56)
Is the remote control
transmitter or the remote
control receiver blocked?
Remove obstructions, dirt, water
droplets or any other blockages.
Remote control
transmitter
CAUTION
If a water leak occurs, close the shutoff valve.
or
Flat-head
screwdriver
is in operation,
(Page 24)
The remote control
batteries
uses
"?
to operate.
Remote control receiver
61
Advertisement
Table of Contents
