Assembly; Loose Parts; Attach Height-Of-Cut Lever; Attach Adjustable Link - Toro Wheel Horse Recycler 78355 Operator's Manual

Assembly

Loose Parts

Note: Use the chart below to identify parts used for assembly.
DESCRIPTION
Height-of-cut lever
Spring
V belt
Idler assembly
Belt cover
Locknut
Operator's Manual

Attach Height-of-Cut Lever

1. Loosen nuts securing quadrant to mower(Fig. 1).
2. Place spring onto long pin of lever. Compress
spring and slide lever into square tube. Insert
short pin of lever into a quadrant hole hold in
position. Tighten quadrant nuts (Fig. 1).
4
5
Figure 1
1. Nut
2. Quadrant
3. Height-of-Cut lever
QTY.
3
2
1
m–2834
4. Spring
5. Square tube
1
Install height-of-cut lever
1
1
1
Install mower to tractor
1
1
1 Read before operating

Attach Adjustable Link

1. Place adjustable link trunnion into rear wheel
shaft bracket and secure with hairpin cotter
(Fig. 2).
2
1
Figure 2
1. Adjustable link trunnion
USE
m–2815
2. Hairpin cotter
3